This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Mesmixer
#1
Buenas.

Suelo utilizar Meshmixer para realizar el vaciado, soportes, etc. en las piezas que luego imprimo con la anycubic photon, pero la mayoría de las veces se me cuelga porque le cuesta mucho cargar las piezas. Utilizo varios softwares de diseño asistido, etc. y ninguno me da problemas nunca. ¿a alguien le ha ocurrido esto mismo? ¿me recomendais algún otro software para este tipo de cosas, principalmente: vaciado y generación de soportes? 

Gracias
  Responder
#2
Podría ser que tu pc no rinda lo suficiente? Qué procesador y gráfica tienes? Y cuanta memoria RAM?
  Responder