This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Error impresion
#1
Hola, tengo una impresora autolevel y estuve imrpimiendo durante unos meses la prusa rc2 no tuve ningun problema, en un momento comenzo a imprimir de manera incorrecta y no logro encontrar el error, probe la T° (es PLA), correas, varillas, extursor, calibre Z y sigue pasando, pasa solo en lugares especificos , adjunto imagenes con el error y una como salia antes de dar el fallo con el mismo g code y todo
[Imagen: 20210104-090335.jpg]

[Imagen: 20210104-090342.jpg]

[Imagen: 20210104-090421.jpg]
  Responder