This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
DUDA Firmware i3 clone
#1
Buenas,ante todo muchas gracias por muchas dudas resueltas con anterioridad.
Tengo una makerfarm i3v con una rampa 1.3,el caso es que quiero actualizar el firmware porque no admite ni la full grhapic ni el autolevel,pero no me aclaro con marlin.
He probado a actualizar a firms posteriores pero no lo consigo.

La ramps 1.3 admite todos los firmwares?de no ser así que placa me recomendáis?
También he pensado en meterle un firmware cualquiera de otra prusa y cambiar parámetros,solo se modifica el config.h en Arduino?

Lo siento si mis preguntas son muy tontas,pero no encuentra nada por la red.

Muchas gracias de antemano.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Error Firmware en Ender V1 con placa MKS Robin E3D 1.0, TMC2209 Palido 1 0 29-12-2023, 10:37 AM
Último mensaje: Simemart
  CONSULTA Hephestos 2 firmware Maclein 64 4,826 22-07-2023, 09:19 PM
Último mensaje: Sonic
  Problema con firmware de impresora jg aurora magic JBKONHIELO 19 412 13-10-2022, 04:12 PM
Último mensaje: JBKONHIELO
  firmware anet a8 plus Snake9229 8 500 26-05-2022, 09:59 PM
Último mensaje: Simemart
  Ender 3 pro firmware alcudel 1 562 16-10-2021, 10:14 AM
Último mensaje: Simemart