This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
DUDA Alimentación hotend
#1
Buenas tardes:

Tengo una Anycubic I3 mega y de buenas a primeras el hotend ha dejado de calentar. He realizado las siguientes pruebas:

-Nuevo hotend: mismo fallo.
-Medido voltaje con un tester: curiosamente, si desenchufo el hotend, y forzando el calentamiento al sistema, me da 12V pero si vuelvo a enchufar el hotend (cualquiera de los dos) el voltaje cae a 0
-Con el hotend desenchufado, el tester me da 0,357 A ¿no es demasiado bajo? (mis conocimientos de electrónica son limitados).


¿Pudiera ser la fuente de alimentación como estoy temiendo?


Un saludo y mil gracias (y felices fiestas quienes las celebren)
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  CONSULTA Mejor hotend Anycubic Chiron danielbonito 1 1,426 08-11-2020, 04:57 AM
Último mensaje: m4nu31
  Hotend V6 en una Chiron DoctorR1 1 783 08-11-2020, 04:54 AM
Último mensaje: m4nu31
  CONSULTA No enciende impresora y hace parpadear a la fuente de alimentación lurdesalbar 2 971 05-11-2020, 06:54 AM
Último mensaje: lurdesalbar
  Hotend no se calienta baltaone 1 1,325 24-12-2019, 06:36 PM
Último mensaje: Bonolux
  CONSULTA problemas con alimentacion filamento xexu1990 2 1,266 07-05-2019, 05:02 PM
Último mensaje: poixil