This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Cura: Skirt, brim y lift Z.
#1
Hola chic@s, llevo poco tiempo con impresora 3d. He pasado de Slic3r a Cura y tengo algunas dudas: No se puede hacer skirt y brim al mismo tiempo? Y lift Z? Esto me iba muy bien con slic3r pero en Cura he probado la retracción en Z pero no da el mismo resultado. Gracias de antemano.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  ¿Doble capa de Brim en Cura? RocaDiesel 6 610 11-11-2021, 12:29 PM
Último mensaje: Simemart
  Modo Experto en Cura 2.5 (Skirt) Mako 2 2,146 14-06-2017, 04:40 PM
Último mensaje: Mako