This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 1 voto(s) - 3 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA problema con endstops
#1
Hola. soy nuevo en esto y solo tengo conocimientos básicos. tengo un problema con los finales de carrera. Smash2 me están volviendo loco. con el pronterface ejecuto M119 y corroboro que los tres están funcionando correctamente. los tres están abiertos al no estar conectados. Pero cuando los quiero llevar al punto de inicio desde el lcd el eje Z gira a la izquierda y no se detiene ni llegando al final. tengo que desconectar la impresora. alguien tuvo un problema similar?
  Responder
#2
Te he contestado en otro hilo, busca a ver en cual de los otros 2 hilos es.

Eso te pasa por poner varios hilos con la misma duda, si tú juegas con nosotros, nosotros también jugamos contigo Lengua
Ulticampy V2: fundiendo plástico sin descanso...
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  DUDA Hola, tengo una duda sobre colocar endstops opticos a la MKS GEN L V1.0 cerverus 4 543 18-01-2022, 12:33 AM
Último mensaje: erjavi_zgz