This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 1 voto(s) - 5 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA NO QUEDA EN EL CENTRO
#1
Hola muy buenas a todos mi nombre es carlos soy de colombia....soy muy nuevo en esto de la impresion 3D y tengo muchas ganas de aprender
en el dia de ayer me llego mi primera impresora 3D una tonxy xy2 y lo arme y todo bien pero el problema radica que el extruzor no queda en el centro 
de la cama ... me gustaria saber si algunos de ustedes sabe como puedo resolver este problema muchisimas gracias ...y estoy algo nervioso en todo 
este proceso XD 
[Imagen: 88240596-1185431578292438-5538854120582021120-n.jpg]

como subir un gif
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Geeetech A10 se queda en "E1 Heating..." y no imprime Alcor 4 0 22-03-2024, 08:31 AM
Último mensaje: Alcor
  CONSULTA Filamento no se queda pegado y no hace forma. stiuws2628 3 695 22-10-2021, 02:47 PM
Último mensaje: Simemart
  CONSULTA El filamento se queda adherido al hotend diego84car 1 714 04-02-2021, 07:59 PM
Último mensaje: Simemart
  CONSULTA NO QUEDA EN EL CENTRO carlos seoanes 2 940 02-03-2020, 11:39 AM
Último mensaje: Lepes
  Queda en Madrid alguna tienda de 3d? PacoMB 0 807 26-09-2019, 12:34 PM
Último mensaje: PacoMB