This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA Líneas verticales en la impresión
#1
Buenas a todos,

Tengo una Mega X, hasta dia de hoy me va de perlas, pero en la última impresión (adjunto imagenes) me ha hecho unas líneas verticales muy raras, nunca las habia hecho hasta ahora.
El material es PLA 1.75mm Smartfil, 200ºC 60ºC
No sé de donde puede salir el problema, alguien me puede ayudar?

Muchas gracias y saludos
[Imagen: IMG-20201028-152511.jpg]

[Imagen: IMG-20201028-152508.jpg]

[Imagen: IMG-20201028-152450.jpg]
  Responder
#2
Ya he encontrado el fallo, el parametro infill overlap era demasiado alto lo he dejado en 15% y se ha solucionado.

Saludos
  Responder