This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA Anet Et4
#1
Sisi1 Tengo una Anet Et4, soy nuevo en el tema, comenzó trabajando impecable y ahora me imprime calado como si fuera una tela, no es macisa la parte exterior y queda muy débil. A que se debe? Alguien me puede ayudar, muchas gracias desde ya[Imagen: 20210225-200619.jpg] Luis

[Imagen: 20210225-235032.jpg]
  Responder
#2
Hola @Luis Eduardo, bienvenido al foro.
Si no has cambiado nada respecto a cuando te imprimía bien, ha sucedido algo en el sistema de extrusión que te está generando una subextrusión, quizá un pequeño atasco en la boquilla/barrel o que el impulsor no esté empujando el filamento de forma correcta: tendrás que revisarlos ambos.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  DUDA Ajustes en Anet et4 Luis Jiménez I 0 0 22-10-2023, 11:07 PM
Último mensaje: Luis Jiménez I
  CONSULTA Backslash en Anet et4 Luis Jiménez I 1 0 22-08-2023, 09:58 PM
Último mensaje: Simemart
  Anet ET4 no me deja actualizar Firmware. Linuco 2 1,201 26-07-2023, 09:01 PM
Último mensaje: covilha6200
  Anet ET4 finware Javier200228 1 851 26-07-2023, 09:00 PM
Último mensaje: covilha6200
  Anet ET4, Reanudar impresión Lex238 20 3,437 09-12-2021, 12:09 AM
Último mensaje: Simemart