This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Ayuda problema con motor eje z
#1
Triste 
buen dia amigos soy nuevo, estoy realizando una impresora 3d core xy y tengo un problema con el eje z al darle pasos se eschucha un sonido y no avanza no se que pasa cambio de driver y sigue igual, cambio el motor y lo coloco en el eje x y si funciona, pense que era por peso o algo asi pero no, el motor y driver funciona con eje x, no se que este mal si esta mal configurado el firmware, no se si me puedan apoyar.

saludos.

tarjeta: mega/ramps 1.4
firmware: sprinter
driver a4988
motor nema 17



  Nusenuse
  Responder
#2
Si tienes la electrónica con Arduino Mega y Ramps 1.4 te recomendaría usar Marlin https://github.com/MarlinFirmware/Marlin

Si el motor no se mueve posiblemente necesites darle más chicha al driver de ese eje.

Saludos.
[Imagen: avatar-3432.gif] [Imagen: guybrush.gif]
-Eh! Mira detrás de tí, ¡¡UN MONO de TRES CABEZAS!!
-Piratas importantes: ¿Que quieres chico?
-Guybrush: Quiero ser bombero.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Marlin TH3 UFW 2.48 error eje Z AYUDA SkyManker 0 205 26-05-2022, 03:42 PM
Último mensaje: SkyManker
  Problema con extrusor y eje Z (Anycubic i3-Trigorilla) Sergimech 7 3,720 05-02-2022, 05:27 PM
Último mensaje: ManCamba
Triste Problema con offset eje Z andreslorite 5 4,903 07-02-2019, 03:22 PM
Último mensaje: andreslorite
  CONSULTA EJE Z PIERDE PASOS. AYUDA PONER MARLIN O ARREGLAR LA PERDIDA DE PASOS Arkaedus 2 2,076 21-09-2018, 05:30 PM
Último mensaje: Simemart
  Problema con home del eje Z fuera del área de impresión omach 3 2,737 29-11-2015, 07:31 PM
Último mensaje: gale9010