This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 7 voto(s) - 4.29 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Autolevel, paso a paso (III): configuración (ACTUALIZADO y EDITADO).
Si se tiene activado el Z Safe Homing, el punto donde se realiza el home de ese eje se configura en los parámetros Z_SAFE_HOMING_X_POINT y Z_SAFE_HOMING_Y_POINT.
Si se desactiva esa funcionalidad, se hará en el origen (punto 0 de los ejes X e Y) aunque, en caso de tener instalado un sensor, habrá que comprobar que este no quede fuera de la cama en esa posición.
  Responder
Como estan chicos he creado un tema respecto a este tema de auto level pero lo dejo por aqui también a ver si alguien me puede echar un cable ya que ando bastante perdido

https://www.spainlabs.com/foros/showthre...+inductivo

mi problema es que al configurar todo y darle compilar me da este bendito error

#error "disable_[xyzijk] is not compatible with home_after_deactivate or z_safe_homing."

que estoy haciendo mal ?
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Autolevel, paso a paso (I): Cambiar el firmware. Simemart 211 51,548 10-03-2024, 07:47 PM
Último mensaje: Pacomt
  CONSULTA Power Loss Recovery Configuracion bbouett 0 0 07-06-2023, 06:55 PM
Último mensaje: bbouett
  Drivers Anet A8 calientes, Placa KO, Opciones. Configuraciòn nueva placa. Landerx 20 3,345 20-07-2021, 06:55 AM
Último mensaje: Landerx
  CONSULTA Configuracion Cura impresion sin hilos DjPacho1 14 4,726 23-03-2021, 06:09 PM
Último mensaje: DjPacho1
Video APORTE MONTAJE ANET A8 PLUS (Completo PASO A PASO) kuadri 1 1,062 20-02-2021, 05:46 PM
Último mensaje: miguelangel