This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Anycubic photon zero
#1
Hola amigos,

Tengo un problema con mi Anycubic photon zero, está imprimiendo capas adicionales, fuera de la figura que se está imprimiendo, ya intente usar diferentes versiones de slicer, me han dicho que solo sería actualizar el firmware pero no he encontrado donde conseguirlo, o no sé si sea hora de cambiar la pantalla pero la máquina tiene 3 meses apenas, ayuda!!!!

[Imagen: IMG-20201210-WA0006.jpg]

[Imagen: IMG-20201210-WA0005.jpg]

direccion html


Archivos adjuntos Miniatura(s)
       
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Error RERF Photon Mono X LogiCat 0 181 19-02-2023, 07:56 PM
Último mensaje: LogiCat
  Anycubic Mega Zero 2.0 Printer Halted Orhugo 0 475 15-09-2022, 04:17 PM
Último mensaje: Orhugo
  Opiniones Anycubic Photon Mono 4K defalt 0 524 04-05-2022, 04:44 PM
Último mensaje: defalt
  Pantalla con rayas cuando se actualiza. photon x mono Sufinegro 5 1,640 30-04-2022, 09:55 PM
Último mensaje: joselarralde
  Problemas temperatura Mega Zero 2.0 Orhugo 2 472 15-03-2022, 07:56 AM
Último mensaje: Orhugo